Embedded Files
Design and fabrication
Design and fabrication
We used Lidar scanner to get the accurate model of the van. While it was at the mechainic's being serviced, we designed and had a CNC fabrication company cut out the components.
Cabinets are made from 18mm birch ply and have been professionally machined by Vertne MD. (http://www.vertne.com/)
The bed slides out for use and stows away for use in the dining area and saloon.
The sliding table can be locked out in different positions depending on requirements.
Kitchen contains cabinets with cubby areas for storage of food and utensils
Flip down counter in the kitchen permits easy access to the cabin from the cargo area.
Plumbing
Plumbing
Plumbing installation with 30 liter fresh water tank and 30 liter gray water tank. The water flow is controlled by a switch and a 10L/min submersible pump.
Electrical
Electrical
Electronics support off-grid camping. Includes:
2 x 180W roof mounted solar panels
110Ah 12V GEL battery
Renogy 20A MPPT Solar Charge controller
Renogy shunt and battery monitor
400W AC inverter
4A plug in charger to recharge the battery
Plugs and extension cords for connecting to sockets
Individual fuse terminal and isolation switch.
The electronics are mounted on a removable wooden board to support maintenance.
Page updated
Report abuse